Operator's Manual iFLEX5
© Hirschmann Rev. E 11/12/08 190147_E
16
4.3 QUICK HOIST LINE SELECTION
If, during the crane operation, the crane is switched over from front to rear hoist, the LMI system has to
be adjusted to this modification. This modification can be entered without having to go through the whole
LMI setup procedure again:
9
Call LMI setup procedure.
Directly call function "Hoist Line
Selection".
Note:
The direct call is not possible, if the
system has been turned off for
more than 2 hours.
Select hoist:
Front Hoist
Rear Hoist
Confirm modification.
(call up the function again if you
have selected the wrong whinch by
mistake)
Note:
If a configuration is selected which is not available on the crane, the system will not accept the
selection and the display will indicate the error code E04.
To Next Page
Loading...
