8
Connecting power supply
1.
Put the connector of the power cord into
the AC IN (AC inlet) of the projector.
2.
Firmly plug the power cord’s plug into
the outlet. In a couple of seconds
after the power supply connection, the
POWER indicator will light up in steady
orange.
Please remember that when the DIRECT POWER ON
function activated, the connection of the power supply make the projector turn on.
WARNING ►Please use extra caution when connecting the power cord, as
incorrect or faulty connections may result in re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in re, electric shock
or other accidents.
NOTICE
►This product is also designed for IT power systems with a phase-
to-phase voltage of 220 to 240 V.
Power cord
AC IN
To Next Page
Loading...
