19
Power on/off
1.
Make sure that the power cord is rmly
and correctly connected to the projector
and the outlet.
Turning on the power
2.
3.
Power on/off
To display the picture, select an input signal according to the section Selecting an
input signal (
21).
Make sure that the POWER indicator is
steady orange (
110). Then, remove the
lens cover.
Press the STANDBY/ON button on the
projector or the remote control. The
projection lamp will light up and the
POWER indicator will begin blinking in
green. When the power is completely on,
the indicator will stop blinking and light in
steady green (
110).
STANDBY/ON button
VIDEO
DOC.CAM
ERA
KEYSTONE
ASPECT
SEARCH
BLA
NK
MUTE
MY BUTTON
POSITION
ESC
MENU
RESE
T
COMPUTER
MY SOURC
E/
AUTO
MAGNIFY
PAGE
DOWN
ON
OFF
FREEZE
UP
࣮
㸩
VOLU
ME
1
2
ENTER
POWER indicator
(continued on next page)
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
(
66) is executed. If you wish to change the settings, refer to the LANGUAGE
(
50) and ALTITUDE (60) menu.
(1) LANGUAGE: Use the ▲/▼/◄/►
buttons to select the desired language
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to
select NORMAL for altitude below
1600 m (5250 feet), otherwise select
HIGH and press the ENTER button of
the remote control or the INPUT button
of the projector to execute.
To Next Page
Loading...
