7.1 Verification of Components
Machine
Nameplate Check
Foundation Bracket 2 pieces
Bolt (M20×90) 2 pieces
Bolt (M20×35) 2 pieces
Nut (M20) 2 pieces
Washer (M20) 2 pieces
Fork Slot Cover 4 pieces
Bolt (M6) 8 pieces
Standard
Accessory
7.2 Instructions When Conveying
Lift the unit balanced.
1.7m
or longer
Put a protection to
prevent the enclosure
from damaged.
Use adhesive tapes
to prevent the front
door from detached
during conveyance.
Hook the wire rope onto
the eye projection of the
common base.
Use strong wires. Adjust
the length to keep the
SCREW’s balance
when hoisting it.
Make sure that the
wires are firmly
hooked in the wooden
tie frame. If the wire
is dislocated from the
frame while conveying
the
SCREW, a seri-
ous personal accident
may happen.
The customer must
provide wooden tie
frame.
■Crane
After transport/grounding, do not
move using tolls such as bars in fork
holes of the common base for adjust-
ing installation position. This is
caused by common base and pack-
age distortion.
OSP-55VAN
OSP-75VAN
Model Total Weight (kg)
OSP-55VAN 1,220
OSP-75VAN 1,390
7.3 Instructions When Installing
WARNING
1． Never put anything inflammable (inflammable solvent etc.) near the Compressor, or such material
may be compressed by the unit and brought explosion.
2． Never allow the operation which uses fire near the compressor. Sparks may get in the unit and dam-
age inside.
CAUTION
33
7. INSTRUCTIONS FOR INSTALLATION
Output (kW)
Model
To Next Page
Loading...