3 - 5
(iii) Numeric inputs are accepted by the ENT key, and
moves to the next item. When an input error has
occurred, the cursor is set to the front line in the
input part while displaying inputs, and then waits
for retype.
Press the ESC key to return to the initial screen
(monitor screen). Even if the ESC key is
pressed while inputting parameters, it won’t be
updated (the previous value is set).
NOTE: When the power supply is turned on, defaults
will be indicated in the item selection number.
(2) Deleting the Present Data Entry
(a) If you made an error in entering data, but have NOT
pressed the ENT key, press the CL key, then re-edit
the value.
(b) If you made an error in entering data and HAVE
pressed the ENT key, press the ESC key for return to
the 1
st
monitor screen then re-edit the value.
(c) Press the DEL key to delete the item in the input part
while editing the program.
When the ESC key is pressed while setting plural
parameters, the item, which the ESC key has pressed,
will be updated.
(3) For canceling the setup conditions, press the ESC key for
return to the 1
st
monitor screen followed by re-setup.
(4) For accessing the next window without changing or entering
values, press the ENT key, or key.
For accessing the previous or next window, press key, or
key.
(5) If the time program is not in use, spectral output can be
performed at any time.
If spectral output is started during data acquisition, the data
is automatically directed to the integrator.
(6) The UI pad operation is disabled when connecting with the
chromato data station
To Next Page
Loading...