Hitachi PRIMAIDE 1440 - Use Time Program Setting

3 - 10
Select TIME CONSTANT.
Press numeric key 2 and then the ENT key.
(3) The following display will be presented.
<Time constant setting screen>
TIME CONSTANT (0.05s=1, 0.1s=2, 0.5s=3,
4 1.0s=4, 2.0s=5, 4.0s=6,8.0s=7)
Set a time constant value.
Press numeric key (1 to 7, usually input 4) and then the
ENT key.
* Default value: 4
(4) Constant setting is now completed and the 1
st
monitor
screen returns.
3.2.3 Use time program setting
It is selectable whether or not to use automatic change of
measurement parameters in response to measurement time
(time program).
(1) Press the
UTLTY
SET UP
key.
(2) The following display will be presented.
<Utility initial screen>
UTILITY (OFFSET=1, TIME CONSTANT=2,
_3 USE PROG=3, PMT VOLT=4, OTHERS=5)
Select USE PROG.
Press numeric key 3 and then the ENT key.
(3) The following display will be presented.
<Time program setting screen>
USE TIME PROGRAM (YES=1, NO=0)
1