3 - 11
Select use (YES=1) or non-use (NO=0) of a time program.
Press a numeric key (1 or 0) and then the ENT key.
* 1: Time program starts by start input.
0: Time program does not start despite start input.
* Default value: 1
(4) Selection or avoidance of a time program is now completed
and the 1
st
monitor screen returns.
When use of a time program is avoided, “-” is indicated for
PROG.
<1st monitor screen>
TIME Ex Em FL PROG LAMP [I]
0.0 250 350 0.0 － Xe
3.2.4 PMT voltage setting
Set photomultiplier voltage for fluorescence detection.
(1) Press the
key.
(2) The following display will be presented.
<Utility initial screen>
UTILITY (OFFSET=1, TIME CONSTANT=2,
_4 USE PROG=3, PMT VOLT=4, OTHERS=5)
Select PMT VOLT.
Press numeric key 4 and then the ENT key.
(3) The following display will be presented.
<PMT voltage setting screen>
PMT VOLT (SUPER HIGH=1, HIGH=2, MID=3,
3 LOW=4, SUPER LOW=5)
To Next Page
Loading...