Hitachi PSC-A32MN - Operation Mode Change

14
P5415644
7.6 OperationModeChange
(1) Selectthetargetgroupatscreenof
“Monitor(AllGroups)”or“Monitor
(Block)”tochangetheoperation
modesetting.
Thepop-upof“Setting”forthe
selectedgroupisdisplayedonthe
touchscreen.
(2) Bytapping“
”or“ ”atthe
OperationMode,itwillswitchin
orderto“COOL”,“HEAT”,“DRY”,
“AUTO”and“FAN”.
*The“AUTO”(Heating/Cooling
AutomaticOperation)willbe
includedasoptionifapplicable.
(3) Tap“Monitorscreen”toreturnto
Monitorscreen.
NOTES:
• Bytapping“<”or“>”atthedetailedsettingscreen,theoperationmodewillbeswitchedtoanothergroupinthe
sameblock.
• Control
Restricted
(Run/StopOnly):Incaseof“Enable”,eachSettingChangeisforallGroupsorBlocks.
SettingChangeisnotpossibleforeachGroup.
• SomeoperationmodecannotbesetdependingonthetypeofAirConditionerUnit.Contactyourdealerorgoto
theinquirycounterofadesignatedmakerfordetailedinformation.
• Ifthesettingsaremixedwhenmultiplegroupsareselected,thedisplaywillremainblank.
<Monitor(AllGroups)> <Monitor(Block)>
(1)(1)
(2)(3)
COOL
HEAT
DRY
AUTO
FAN