Hitachi RAS-3-HVNC - Page 345

10. Servicing
331
SMGB0079 rev.0 - 01/2013
10

Removing other electrical components
1 Remove the pipe cover following Removing pipe cover.
2 Remove 3 xing screws and remove the upper cover.
3 Remove the electrical box cover.
4 Removing Electrical Components.
Remove the xing screw and remove the reactor.
• To mount components be sure to match the wiring connection with the mark band codes.
1
2
3
4
5
6
1. Electrical box cover.
2. Partition plate.
3. Fuse.
4. Electrical box.
5. Reactor.
6. See the note.
N O T E
• ThePCBcannotberemovedfromtheelectricalbox.ToreplacePCBtheentireelectricalboxmustbereplaced.
• DONOTtouchelectricalcomponentswhiletheLED1(Red)isONtoavoidelectricalshock.WaituntiltheLED
turnsoff.