Hitachi RAS-3-HVNC - Removing Reversing Valve Coil

10. Servicing
368
SMGB0079 rev.0 - 01/2013
10.3.3.10 Removing reversing valve coil
1 Remove the service cover following Removing service cover in this chapter.
D A N G E R
DONOTtouchelectricalcomponentswhiletheLED1(Red)isONtoavoid electricalshock.WaituntiltheLED
turnsoff.
2 Remove the connector (PCN100) on the control PCB (PCB1) of the electrical box.
3 Remove the reversing valve coil by removing 1 screw xing the coil.
1. Upper cover.
2. Power Plate.
3. PCN6.
4. Fixing screw for reversing valve coil.
5. Reversing valve coil.
6. Compressor.
7. Reversing valve.
8. Electrical Box.
1
2
3
4
5
6
7
8
4 When reassembling, perform the procedure in the reverse way of removing.
N O T E
Fixthewiresbyplasticbandstotheoriginalposition.