63
Fan 1 Motor Current 22 0~9.9(A)
Fan 2 Motor Current 23 0~9.9(A)
Indoor Unit Address 24
0~63
(Indoor Unit No.)
Indoor Electronic Expansion Valve Opening 25 0
～
100(%)
Liquid Pipe Temp. of Indoor Unit 26 *1 -19
～
127(°C)
Gas Pipe Temp. of Indoor Unit 27 *1 -19
～
127(°C)
Indoor Unit Inlet Air Temp. 28 *1 -19
～
127(°C)
Indoor Unit Outlet Air Temp. 29 *1 -19
～
127(°C)
Cause Code of Indoor Unit Stoppage 30 0~99
Accumulated Operating Time of Comp. 150 *2*3 0000
～
9999(×10 hours)
Accumulated Operating Time of Compressor
(Restorable)
151 *2*3 0000
～
9999(×10 hours)
Outdoor Unit Alarm Code 152 00
～
FF
Cause Code of Comp. Inverter Stoppage 153 0
～
99
Cause Code of Fan Stoppage (Lower Outdoor Fan) 154 0
～
99
Cause Code of Fan Stoppage (Upper Outdoor Fan) 155 0
～
99
Abnormal Data Record (No.1) 156
……..
Accumulated Operating Time,
Alarm Code or Cause Code of I.U.
Stoppage, Cause Code of Inverter/
Fan Stoppage
…….. … …
Abnormal Data Record (No.9)
Capacity of Outdoor unit 157
Capacity Code of Outdoor Unit. For
example, 40 represent that 40÷8=
[5]HP. Besides the 3HP, its capacity
code is 22.
Total Capacity of Indoor Unit Connected 158 *1 0
～
199
Connected Indoor Unit Number 159 0.
～
64. (pcs)
System Refrigerant Address 160 0
～
63 (Refrigerant System No.)
Notes
:
● *1: When information number is over than 100, the last two digits ash.
For example：
When number is "-19", SEG1 displays
When number is "120", SEG1 ashes
● *2: Alternately upper 2 digits and lower 2 digits are indicated every 0.5 sec.
For example：
When number is "194", SEG1 displays alternately every 0.5 sec.
When number is "0", SEG1 displays alternately every 0.5 sec.
When number is "-15", SEG1 displays alternately every 0.5 sec.
● *3: For resetting the Accumulated Operating Time (Restorable), press PSW1 for 5sec. While the Accumulated Operating Time
(Restorable) is indicated.
TROUBLESHOOTING
To Next Page
Loading...
