Hitachi RAW-35RHC - Central Operation Functions

3 Control functions
Central Operation functions
SMGB0135 rev.0 - 06/2020
27
3
3.11 Central Operation functions
IncasethattheYUTAMPOunitisconnectedtoacentraloperationdevice(KNX,Modbus,etc.)itisnecessarytocongurethecontrol
type (local or full) and the H-LINK Address for the refrigerant cycle and the indoor unit.
In case that the YUTAMPO unit is connected a
central operation device (KNX,Modbus, etc.)
• Local: Central orders are disabled
• Full: Central orders are enabled
H-LINK communication addresses must be
assigned in case that the YUTAMPO unit is
connected to a central operation device (Default
values: 0:0)