7 Servicing
RCD-(0.8-6.0)FSR - 2-way cassette
SMGB0137 rev.0 - 05/2021
202
Method of Attaching Air Filter
a. Place the air lter on the top of the air inlet at grille.
b. Hold the trim of the air lter.
Air inlet at grille
c. Insert the hooks into the holes on the air lter.
P-AP90DNA
P-AP160DNA
Front side
Hook
Rear side
Hole on the air lter
Hook
Hook
Front side
Hook
Rear side
Hole on the air lter
d. Slide the air lter only on the front side in order to
lock the hooks.
P-AP90DNA
P-AP160DNA
After sliding
Direction of slide
Large size lter
Small size lter
After sliding
e. Attach the air lter on the rear side.
3 Remove the air inlet at grille
Remove the supporting string from the air panel.
•
Open the air inlet at grille at an approximately 40° angle from the air panel surface.
•
Tilting the air inlet at grille, lift it up to remove it.
? NOTE
Although the air inlet at grille can be opened up to 90°, it cannot be removed from the air panel at the angle. Tilt it at a 40° angle when
removing it.
40
o
Air inlet at grille
Air Panel
Ceiling
Tilting the air inlet at grille, lift it up to remove it.
Attach the air inlet at grille in the reverse procedure for removing. The supporting string is attached to the side plate.
To Next Page
Loading...
