7 Servicing
RPI(L/H)-(0.4-6.0)FSRE - Ducted indoor unit
SMGB0137 rev.0 - 05/2021
227
7
7.5.8 Removal of the thermistors from the liquid and gas pipes
1 Remove the motor and service covers as explained in “7.5.4 Removal of the motor cover” and “7.5.5 Removal of the
service cover”.
2 Remove the drain pan as explained in “7.5.6 Removal of the drain pan”.
3 Remove the insulation covering the thermistors
4 Remove the special clamp
5 Remove the gas or liquid thermistor.
? NOTE
• To disconnect and remove the appropriate thermistor, previously see the chapter corresponding to the wiring diagrams in “3.3 Wiring
diagrams”.
• Cover the thermistors with pipe insulation using the factory-supplied. Replace them if damaged during maintenance work.
RPI-(1.5-6.0)FSRE
Liquid thermistor
Gas thermistor
To Next Page
Loading...
