Hitachi RCIM-1.0FSRE - Removal Of The Inlet And Outlet Air Thermistors

7 Servicing
RPI-(8.0-20.0)FSN3(P)E(-f) - Ducted indoor unit
SMGB0137 rev.0 - 05/2021
236
7.6.3 Removal of the inlet and outlet air thermistors
Inlet air thermistor
1 Remove the air lter as indicated in chapter “7.6.8 Removal of
the air lter”.
? NOTE
The inlet air thermistor -A- is located on the left-hand side of the air inlet
to the unit.
2 Remove the electrical box cover as indicated in chapter
“7.6.1 Removal of the electrical box cover”.
3 Disconnect and remove the thermistor (x2 thermistors in
RPI- (16.0/20.0)FSN3PE(-f))
? NOTE
To disconnect and remove the appropriate thermistor, previously see the
chapter corresponding to the wiring diagrams in this Manual.
Nº Part
1 Tie
2 Cable clamp
3 Thermistor
Outlet air thermistor
The outlet air thermistor -B- is located on the right-hand side of the
air outlet from the unit.
1 Remove the electrical box cover as indicated in chapter
“7.6.1 Removal of the electrical box cover”.
2 Disconnect and remove the thermistor (x2 thermistors in
RPI- (16.0/20.0)FSN3PE(-f)).
? NOTE
To disconnect and remove the appropriate thermistor, previously see the
chapter corresponding to the wiring diagrams in this Manual.
Nº Part
1 Tie
2 Cable clamp
3 Thermistor