Hitachi RCIM-1.0FSRE - Remove The Electrical Box Cover

7 Servicing
RPK-FSR(H)M - Wall mounted
SMGB0137 rev.0 - 05/2021
248
7.7.3 Remove the electrical box cover
1 Remove the at panel as indicated in section “7.7.2 Removal of the front panel”. The electrical box cover can be
opened without removing the front panel.
2 Remove one (1) screw xing the terminal block cover to remove it. Also remove 1 screw xing the electrical box cover
to remove it.
3 Then, remove the power supply wiring, the transition wiring and the wiring for the remote control switch from the
terminal block.
4 Remove the connectors (on the PCB1) for the freeze protection thermistor, gas pipe thermistor, inlet air thermistor,
outlet thermistor, auto-louver, fan motor and expansion valve coil.
5 Remove the wirings for the freeze protection thermistor, gas pipe thermistor, inlet air thermistor and the expansion
valve coil from the wiring outlet at the upper part. Also remove the wirings for the outlet air thermistor, auto-louver and
fan motor from the wiring outlet at the lower part.
6 Remove the earth screw to disconnect earth wire between the heat exchanger and the electrical box.
7 Remove two (2) screws xing the electrical box to dismount it from the indoor unit body.
? NOTE
If the unit with the expansion valve kit is used, regard “expansion valve coil” as “expansion valve relay cord”
Screw for electrical box
Screw for electrical box cover
Screw for terminal block cover
Switch cover
Terminal block cover
and switch cover
Screw for electrical box
Screw for earth wiring
Electrical box cover
Example for 0.6HP to 1.5HP
Electrical box
cover
Switch cover
A 12
Screw for earth
wiring connection
Electrical
box cover
Wire for receiver kit
Terminal board
for remote control
switch cable
Terminal board for
power source
Fix the wires by
cord clamp