Hitachi RCIM-1.0FSRE - Filter Box; For Rci-Fsr Indoor Units: B-160 H2; For RCI-FSR Indoor Units: B-160 H2

2 Optional accessories
Filter box
SMGB0137 rev.0 - 05/2021
29
2
2.5 Filter box
2.5.1 For RCI-FSR indoor units: B-160H2
Thedimensionsofthelterboxareshowninthefollowinggure.
20 50
10
5
55
549
549 700 800
700
800
(Opening dimension)
(Installation dimension)
(Opening dimension)
Filter holder
(resin)
U-shaped hook
(2 portions)
Corner frame
(galvanizedsteelplate)
Counter mark
(refrigerant pipe side)
Fixing plate
(4 portions)
Polystyrene
(Installation dimension)
Indoor unit side Air panel side
Packing (EPDM)
10 (Before compression)
5 (After compression)
(Installation height)
Insulation
(Polyethylene)
Whenthelterboxisinstalled,thetotalheightoftheunitincreasesbyapproximately55mm.Therefore,payattentionto
the installation space.
Bearinmindthatthesizebeforecompressionis10mm,butthesizeisreducedaftercompressionto5mm.
840
5512
50
a
b
5
155
Min.10
Packing
Indoor unit
Airlter
Longlifelter
(attachedwithairpanel)
Filter box
Ceiling
Air panel
Air inlet grille
(attachedwithairpanel)
Direction to
remove the
lter
Installation
height
155 (Suspending position)
5 (After compression)
Dimensions
Model a b
1.0 - 2.5 291 236
3.0 - 6.0 341 286