7 Servicing
RPK-FSR(H)M - Wall mounted
SMGB0137 rev.0 - 05/2021
263
7
5 Twist away the motor support B out of the rubber bush. Pull the motor support B out to avoid catch being caught
therein.
6 Remove the motor wire out of the clamp to pull the fan motor out.
7 When to mount fan motor and fan, take the reverse steps of it. Degree of pulling out of fan motor lead wire is
approximately 20°. See illustration below.
8 From the view of downward of the body, fan places in where the right edge of the fan’s cutout contact the body. After
mounting, rotate the fan by the hand to check for no friction.
Fan
motor
Motor support B
Body
Catch
Cutout
of fan
Twist in the direction of the
arrows to avoid catch being
caught therein.
Fan places in where the right edge of
the fan’s cutout contacts the body
Cross section
Fan Motor
Lead Wire
(Approx. 20°)
To Next Page
Loading...
