Hitachi RCIM-1.0FSRE - Page 61

3 Electrical and control settings
Unit electrical wiring and connection
SMGB0137 rev.0 - 05/2021
51
3
Terminal board connections
Electrical
boxcover
Switch
cover
A 12
Screw for earth wiring
connection
Electricalbox
cover
Wireforreceiverkitorwiredremotecontrol
Terminal board
for remote control
switch cable and
transmission wire
Terminal board for
power source
Fixthewires
by cord clamp
DIP switch location
PCB2
Switch cover
DSW5
RSW1
RSW2
DSW6
DSW9 DSW2
SW2
DSW3
Test runs
! CAUTION
• Becarefulduringthetestruns,assomeofthesafetyfunctionsremaindisabled:theunitsoperatefortwohourswithoutswitchingo
via the thermostat. The three-minute compressor protection is not enabled during the test.
• Secure the rubber bushes to the panel using adhesive when the outdoor unit ducts are not used.
• The compressor remains at a standstill during forced stoppage.