Hitachi SJ700-2 Series - Preparing for Programming

Chapter 1 Introduction
1 - 5
1.2 Preparing for Programming
To create user programs with the easy sequence function of the SJ700 inverter, you must prepare the
following devices and software:
(1) SJ700 inverter
(2) Personal computer (PC) (Windows system)
(3) Optional programming software EzSQ
(4) Optional PC-inverter connection cable
PC port: serial RS232C port
Inverter port: Operator-connection port
The following figure shows the basic system configuration for programming.
- Install EzSQ on your Windows personal computer, and connect the personal computer to the SJ700
inverter via the PC-inverter connection cable.
- After completing these preparations, you can operate EzSQ to create a user program and download it
to the SJ700 inverter.
SJ700 Inverter
Commercially
available Windows
personal computer
Optional programming
software EzSQ
Optional PC-Inverter
connection cable
SJ700
Installation
Downloadin
g
U
p
loadin
g
Pro
g
rammin
g
User
program