Chapter 4 How To Use EzSQ
4 - 10
4.5 Program Editing Functions
This section explains the edit functions (commands) you can use when describing a program.
You can use the edit commands in both the "Code Window" and "Data Window."
(1) "Undo"
The "Undo" command is effective after an editing operation (e.g., input) has been performed. The
command cancels the preceding editing operation.
- Select "Undo" from the "Edit" menu on the menu bar.
(You can also execute this command by clicking the icon under the menu bar or pressing the
"Ctrl + U" keys on the keyboard.)
(2) "Redo"
The "Redo" command is effective after the "Undo" command has been executed. This command
restores the undone editing operation (e.g., input).
- Select "Redo" from the "Edit" menu on the menu bar.
(You can also execute this command by clicking the icon under the menu bar or pressing the
"Ctrl + R" keys on the keyboard.)
(3) "Cut"
The "Cut" command cuts out one or more selected lines. You can use this command to delete
program lines.
1) Select the line to be deleted.
2) Select "Cut" from the "Edit" menu on the menu bar.
(You can also execute this command by clicking the icon under the menu bar or pressing the
"Ctrl + X" keys on the keyboard.)
3) The selected line is deleted. The deleted line can be pasted with the "Paste" command as
described below.
The lines following the deleted line are shifted upward.
(4) "Copy"
The "Copy" command copies one or more selected lines.
1) Select the line to be copied.
2) Select "Copy" from the "Edit" menu on the menu bar.
(You can also execute this command by clicking the icon under the menu bar or pressing the
"Ctrl + C" keys on the keyboard.)
3) The selected line is copied. The copied line can be pasted with the "Paste" command as described
below.
(5) "Paste"
The "Paste" command is effective after the "Cut" or "Copy" command has been executed. This
command pastes one or more lines that were cut out or copied in the program.
1) Select the line where to paste the cut-out or copied line(s).
2) Select "Paste" from the "Edit" menu on the menu bar.
(You can also execute this command by clicking the icon under the menu bar or pressing the
"Ctrl + V" keys on the keyboard.)
3) The cutout or copied line(s) is (are) inserted in (and after) the selected line.
To Next Page
Loading...
