Chapter 4 How To Use EzSQ
4 - 3
4.2 Flow of Programming
The following figure shows the flow of programming for the easy sequence function.
Start EzSQ
Create a new program
Give the program a file name
Enter the program in the "Code Window"
Set the initial values of variables in the "Data Window"
Temporarily save the created program
Compile the program
Did compilation end normally?
Download the program to the inverter
Was download completed?
Verify program operation
Is program operation normal?
Save the downloaded program in EEPROM
Store the created program
Exit EzSQ
Correct the program
Correct the data
Yes
No
No
Yes
To Next Page
Loading...
