Chapter 4 How To Use EzSQ
4 - 14
4.7 Compiling a Program
After entering a program and setting the values of variables, compile the program as follows:
(1) Select "Compile" from the "Run" menu on the menu bar.
(You can also execute the "Compile" command by clicking the icon under the menu bar or
pressing the "Ctrl + F9" keys on the keyboard.)
(2) EzSQ compiles the program and displays a normal-end message when no error is detected. Then,
the program is ready for downloading.
Note: If EzSQ detects an error during compilation, it displays the line where the error is detected (in case
of an instruction format error) or both the line and string where the error is detected (in case of a
parameter error). In either case, correct the indicated line of the program.
To Next Page
Loading...
