Hitachi SJ700-2 Series - Page 57

Chapter 5 Instruction Words
5 - 3
(4) Input/output control, timer control, and inverter control instructions
Instruction format
Instructio
n name
Mnemonic code First argument
Second
argument
Third argument
Fourth
argum
ent
Fifth
argum
ent
Description
<variable> = X (ii)
Fetches general-purpose contact
information and stores it in <variable>. (0
= off, 1 = on)
General-
purpose
contact
input
<variable> = Xw
Fetches general-purpose contact
information and stores it as word data in
<variable>.
Y (ii) =
<variable/consta
nt)
Outputs bit data to a general-purpose
contact. (0 = off, 1 = on)
General-
purpose
contact
output
Yw =
<variable/consta
nt)
Outputs word data to a general-purpose
contact.
Inverter
operation
command
<input
terminal> =
<variable/consta
nt)
Operates an inverter input terminal. (0 =
off, 1 = on)
<variable> =
<output
terminal>
Fetches information from an inverter
output terminal.
Inverter
operation
monitorin
g
<variable> =
<input terminal>
=
Fetches information from an inverter
input terminal.
delay on <variable 1> TD (k)
<variable 2/
constant>
Turns on the terminal specified by
<variable 1> after the time specified by
<variable2/constant> elapses.
Delay
operation
delay off <variable 1> TD (k)
<variable 2/
constant>
Turns off the terminal specified by
<variable 1> after the time specified by
<variable2/constant> elapses.
timer set TD (k)
<variable/
constant)
Sets <variable/constant> in a specified
timer and starts the timer.
Timer
control
timer off TD (k) Stops the specified timer.
<variable> = UB (ii)
Fetches internal user contact information
and stores it in <variable>. (0 = off, 1 =
on)
<variable> = UBw
Fetches internal user contact information
and stores it as word data in <variable>.
UB (ii) =
<variable/consta
nt)
Outputs bit data to an internal user
contact. (0 = off, 1 = on)
Internal
user
contact
control
UBw =
<variable/consta
nt)
Outputs word data to an internal user
contact.
Paramete
r change
chg param <display code>
<variable/
constant)
Replaces the content of <display code>
with <variable/constant>.
Paramete
r reading
mon param <display code> <variable>
Reads the content of <display code> into
<variable>.
Stop
inverter
stop
the inverter decelerate and stop the
motor
Umon(ii) = <variable>
Displays <variable> on user monitor (ii)
Umon(ii) = <variable1> <operators> <variable2>
Displays the result of operation with
<variable1> and <variable2> on user
monitor (ii)
User
monitor
<variable>= Umon(ii)
Value of user monitor (ii) is read out to
<variable>
User trip trip <variable> Makes the inverter trip