44
(4) When you change Character height of both Nozzle 1 and Nozzle 2 to 50:
Step 1. Select Nozzle 1 and Nozzle 2 respectively, and write “50” on Character height by Holding
Register writing.
(5) When you get Unit information of IJ Printer:
Step 1. Read Unit information by Input Register reading.
External unit IJ Printer
1 Read Unit information by Input Register reading. (function code: 0x04).
[Request message data of Input Register reading]
0000 0000 0006 01 04 0000 0008
[Response message data of Input Register reading]
0000 0000 0013 01 04 10 0031 0031 0030 0030 0000 0000 0000 0000 (Hexadecimal notation)
Input Register reading request
Input Register reading response
External unit IJ Printer
1 Select Nozzle 1 and Nozzle 2 respectively, and write “50” on Character height by Holding
Register writing. (function code: 0x10).
[Request message data of Holding Register writing]
0000 0000 0009 03 10 19A0 0001 02 0032
[Response message data of Holding Register writing]
0000 0000 0006 03 10 19A0 0001 (Hexadecimal notation)
Reflection in progress
Holding Register writing request
Holding Register writing response
To Next Page
Loading...
