HITEC PMAC 3000 - System Settings



PMAC 3000 Page26

Print–Sendsthepagetothedefaultprinter.
Exit–ReturnstotheGUIMainScreen.SeeFigure22.

SystemSettings
TheSystemSettingsscreenallowstheusertoadjusteverythingfoundundertheSystemSettings
MenuinthePMAC3000,buthereitisalloutintheopenandeasiertouse.SeeFigure24.



Figure24‐SystemSettingsScreen

Time(24Hr)–Enterthecurrenttimein24hourmode.Whensettingthetime,theusermust
alwayssetthetimein24hourmode.Thetimemaybedisplayedineither12hourmode,or24
hourmode.
Date(MM/DD/YYYY)–Enterthecurrentdateinthespecifiedformat.

Display12Hr.Format–Checktheboxtoselect12hourmodefordisplaypurposes.Uncheckthe
boxtoselect24hourmodefordisplaypurposes.
AnalogOutput–Selecttherangeofanalogoutputvoltagedesired.Theanalogoutputvoltage
is spread over the entirerange of the sensor capacity, fromnegative full scale to positive full
scale.Thismeansthat,forexample,selecting+/‐10Vwillcause‐10Voutputwithanegativefull
scaleload,and+10Vwithapositivefullscaleload.Noloadwillproduce0Voutput.If0‐5Vwere
selected,negativefull  scale load
wouldproduce0Vand positivefullscaleload wouldproduce
5V.Zeroloadwouldproduce2.5V.
Enable–Turnsontheanalogoutputcircuitrywhenenabled.Disablingtheanalogoutputwhen
notneededwillincreasebatterylifebyabout10%.
PowerOffTimer–SelecthowlongthePMAC3000
willremainpoweredupwithoutactivityat
thesensororanybuttonpresses.Selectionsrangefrom1minutetoNever.
DisplayBrightness–Thiscontrolallowstheusertocontrolhowbrightthedisplayis.Dimmer
displaysincreasebatterylife.Ofcourse,brighterdisplaysareeasiertosee.