HITEC X1 Pro - Page 6

6
WARNINGS AND SAFETY NOTES (cont.)
• A battery pack which consists of dierent types of cells
(including dierent manufacturer’s cells)
• A battery that is already fully charged or just slightly
discharged
• Any non-rechargeable batteries (these pose an explo-
sion hazard)
• A faulty or damaged battery
• Batteries installed in a device or which are electrically
linked to other components
• Batteries that are not expressly stated by the manufac-
turer to be suitable for the currents the charger delivers
during the charge process
PLEASE BEAR IN MIND THE FOLLOWING POINTS BEFORE
YOU COMMENCE CHARGING:
• Did you select the appropriate program suitable for the type
of battery you are charging?
• Did you set up the adequate current for charging or discharg-
ing?
• Have you checked the battery voltage? Lithium battery packs
can be wired in parallel and in series, i.e. a 2-cell pack can be
3.7V (in parallel) or 7.4V (in series).
• Have you checked that all connections are rm and secure?
• Make sure there are no intermittent contacts at any point in
the circuit.