Hive Active Heating - How to boost your hot water for a short time

13
2c – Testing the boiler
To test the receiver to boiler connection follow these steps:
1
Visually check the wirin to confirm that the connections have been
carried out correctly, referrin to the labels on the wires and any
photoraphs taken before replacement bean
2
Confirm that the receiver’s front panel is in place and that it is safe
to commission the boiler
3
Check the middle liht on the Hub is flashin Amber – if it isn’t,
o back to step 1
4
Restore power to the central heatin system – the receiver’s status
liht should flash AMBER. This means it’s ready to connect to the
hub and thermostat
5
Test the receiver’s wirin to the heatin system by pressin the
Central heatin button. The GREEN liht above the Central
heatin button should come on and the boiler should fire up.
Once you’ve completed these tests, leave the receiver switched on
with the status liht flashin – this means it’s ready to connect to
the hub and thermostat. Next, install the thermostat.