32
To complete installation of the remainin heatin zone(s) use either the hub
or the Hive app or online dashboard:
5a – Using the hub
1
Press the button at the rear of the hub
for 1 second and release it. The middle
LED should start to flash AMBER
2
Now add the batteries to one new thermostat
3
Wait until the thermostat display stops showin ‘Search’.
Now check that the status liht on one of the receivers that was
previously flashin AMBER has turned solid GREEN
4
If there are still more zones to install, repeat steps 2-3
5
When all zones have been added, press the button on the
rear of the hub to exit from pairin mode. The middle LED
will stop flashin.
Button
To Next Page
Loading...
