Hive Active Heating - To Switch Back to ‘Remote Heating’ Mode:

To switch back to ‘remote heating’ mode:
a. Switch the hub off and then on aain. If it beins to flash AMBER continue
on to step b. If all the lihts o out and the hub does not flash AMBER,
lo into hivehome.com, open the ‘Devices’ pae and click ‘Add devices’.
The hub should now bein to flash AMBER.
b. Now follow steps 1-5 on page 19, but note that the lihts will be different.
At step 3 the receiver’s status liht will initially flash WHITE/PINK and in
step 4 it will chane to AMBER (for ‘remote heatin’) once you have held
the
Central heatin button down.
At any time you can check what mode the receiver is set to by switchin it
off then on. When power is restored the status liht will flash for 5 seconds –
AMBER for Hive Active Heatin, WHITE for ‘stand-alone’ mode.
20