Hive Active Heating - Icons you might see on your thermostat

Activating stand-alone mode
1
Remove the batteries from the thermostat
2
Switch off the boiler and receiver
3
Wait at least 5 seconds, then turn the boiler and receiver back on.
The receiver’s status liht will bein to flash AMBER
4
Press and hold the heating button for at least 10 seconds – until the
status light begins to flash WHITE. The receiver is now in ‘stand-alone’
mode and is searchin for a thermostat
5
Insert the batteries into the thermostat, press and hold down the
menu and back buttons on the thermostat and follow the
factory reset instructions on screen. After about 10 seconds, ‘Welcome’
and ‘Searchin…’ will be displayed on screen. If the thermostat shows
‘REJOIN’ then try steps 1 and 5 aain.
19