Hobart Handler 190 Technical Manual

TM-260 273 Page 42 Handler 190
Description
Part
No.
Dia.
Mkgs.
Item
No.
Figure 9-1. Main Assembly (Continued)
Quantity
44 248 827 Label, Weld Chart 1... ............... .. ..............................................
45 204 711 Latch 1... ............... .. .........................................................
46 CR3 217 585 Contactor 1... ..... .... .. .....................................................
47 Label, Nameplate (Order By Model And Serial Number) 1... .......................... .............
48 048 282 Rcpt W/Skts, (Service Kit) 1... ............... .. .......................................
49 228 643 Plate, Stiffener Base 1... ............... .. ............................................
50 229 794 Label, Spoolgun/Mig Gun 1... ............... .. .......................................
221 037 Regulator/Flowmeter, 10−50 CFH Argon/CO
2
1..................... .. ......................
183 581 Hose, Assembly Gas 1..................... .. ...........................................
+When ordering a component originally displaying a precautionary label, the label should also be ordered.
To maintain the factory original performance of your equipment, use only Manufacturer’s Suggested
Replacement Parts. Model and serial number required when ordering parts from your local distributor.

Hobart Handler 190 Specifications

General

Input Voltage	230 V
Amperage Output	25-190 A
Weldable Materials	Steel, Stainless Steel, Aluminum
Weight	68 lbs
Spool Size Capacity	4 or 8 inch
Input Current	20 A
Input Frequency	60 Hz
Processes	MIG (GMAW), Flux-Cored (FCAW)
Input Phase	Single Phase
Duty Cycle	30% at 130 A
Material Thickness	24 ga. - 5/16 in. (Steel)
Wire Size Range	0.023-0.035 in (0.6-0.9 mm) solid, 0.030-0.045 in (0.8-1.2 mm) flux-cored