17
Programming a Recipe [SEt . . . rECP]
This function allows you to program any of 9 mixer recipes with up to 6 steps in each recipe.
Follow instructions in Entering a Special Function on the previous page to enter SEt . .
.rECP.
After entering the Access Code, the display of SEt . . .
rECP indicates that you can now program a recipe.
All active recipe keys are lit continuously; inactive recipe
keys blink.
• Press the recipe key you want to program (1–9). It
stays lit.
• Set the speed and mix time for step one by turning the
speed and time dials; press ENTER to go to the next
step. If the recipe was previously programmed, step 1
of X displays to indicate the first of up to 6 steps
programmed for this recipe. The example shows that Stir
speed was previously programmed for 1 minute and 30
seconds.
• Set the speed and time for each step of the recipe, then
press ENTER to go to the next step. Repeat for each
step.
• If you add more steps than were previously
programmed, the step display does not update
until the recipe has been saved. The step display
can show step 4 of 3 during programming.
• Turn timer dial counterclockwise to End to terminate
the recipe. This sets the previous step as the last
step.
• Turn timer dial counterclockwise to End to terminate
the recipe. This sets the previous step as the last
step.
• To save the recipe, press the lit recipe button.
• Continue programming other recipes; or press ENTER
for 5 seconds to exit SEt . . . rECP and return to
standard Timer Mode.
Pro
rammin
a Pause
• If you need to stop mixing to add ingredients or to rest
the dough, you can program a Pause step. Turn the
Speed dial to the top (PAUS displays); set the timer
dial for that amount of time; press ENTER.
• The mixer cannot be restarted while the pause step is
counting down. If programming a Pause to add
ingredients, its best to set the Pause Time for a short
amount of time.
• Pause cannot be entered in first or last step of a
recipe.
To Next Page
Loading...
Need help?
General
