EasyManua.ls Logo

Hobby Excellent - 10 Built-In Devices; General Information; Heating; Truma-S-Hot-Air Heating

Hobby Excellent
177 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10. Built-in devices
108
10.1 General information
In this chapter, you will nd information on the devices that have
been built into the caravan. This information refers only to the ope-
ration of these devices.
To some extent, the devices described are special accessories.
For further information on the individual built-in devices, please re-
fer to the separate operating instructions that have been included
in the blue service bag found in the vehicle.
Built-in devices may only be repaired by specialists.
Only the device manufacturer‘s original spare parts
may be used for maintenance and repair work.
Any changes to the built-in devices as well as non-
compliance with the rules for use will cause the
guarantee to become void and lead to the exclusion of
liability claims. Furthermore, the operating licence for
the device will become void and, in some countries,
this means that the operating licence for the vehicle
is also void.
Please also refer to the instructions in Chapter 9
for operating gas devices, gas regulators and gas
bottles.
Please observe the instructions in Chapter 7 for ope-
rating electrical devices.
Heating while driving is forbidden.
The space behind the heating may not be used as
stowage space.
To start the device, the heating system must either be
connected to a 230V power supply or 12V via the trailer's
battery, should you be using a stand-alone power supply.
General information
10.2 Heating
10.2.1 Truma-S hot-air heater
Before rst use
Several air outlet nozzles have been built into the caravan.
Pipes lead the hot air to the air outlet nozzles. Set the air vents
so that the hot air can escape to where it is required.
Check whether the ue is unobstructed. Any covers must al-
ways be removed.
Before the rst ignition, ensure that the batteries in the automa-
tic ignitor are working properly.
If necessary, ll the therme/boiler* with water.
Use the control panel to switch the device on.
Truma-S- hot-air heating
Place of installation
- In the closet or the corner of the ue

Table of Contents

Related product manuals