10. Built-in devices
112
Truma-Combi-hot-air heater
The combined LPG heating consists of a warm air heater with an
integrated hot water boiler (capacity: 10 l). The heating system is
fully operational with or without the hot water system. It has been
installed in models 660 WFC, 560 WFU and 495 WFB instead of
the standard Truma-S hot-air heating system.
As an optional extra, these models can be tted with the Combi
E heating system, which has additional heating rods for electric
operation.
10.2.3 Truma Combi Heating System C4/C6 (E)
Initial operation
• Several air vents have been built into the trailer.
Pipes transport the hot air to the air vents. Set the air vents so
that the hot air can escape to where it is required.
• Check that the chimney is clear. Remove any covers.
• Open the gas bottle and gas shuto valve on the gas pipe.
Place of installation:
- side seat in the seating arrangement
• Only operate the device if it is in perfect technical
condition.
• Always have malfunctions repaired immediately.
Only repair malfunctions yourself if such malfunc-
tions are described in the troubleshooting instruc-
tions in this manual.
• Do not carry out any repairs on or make any
changes to the device.
• Only have a defect device repaired by the manuf-
acturer or their service department.
If the system's power supply is interrupted, the time
must be reset.
Use the panel by the entrance to operate the basic
functions of the Combi heating system (see Chapter 7).
The change to the iNet-ready version was carried out
during the current season. Depending on when the
trailer was manufactured, iNet-ready functions are
available, whereby the Truma CP plus control panel
functions as an interface for operating connected
devices via the Truma App and iNet Box.
To Next Page
Loading...