10. Built-in devices
122
Malfunction
If there is a malfunction, the control panel will immediately go to
“Malfunction” mode and display the Malfunction error code.
E = Malfunction
41 = Error code
H = Heating
Cause eliminated / Return to setting mode
• Press the adjusting knob / pushbutton.
• The corresponding device will be restarted.
Cause not eliminated / Return to setting mode
• Press the reset button.
If the cause has not been eliminated, the malfunction will occur
again and the control panel will once again go to “Malfunction”
mode.
Due to an internal lag feed in the connected devices,
this may take a few minutes.
In this case, the malfunction will not be acknowledged
on the control panel and the warning icon will continue
to be displayed. The device will remain in a state of
malfunction. Other connected devices can be operated.
Maintenance
This device requires no maintenance. Use a non-abrasive cloth
dampened with water to clean the front. If this is not sucient, use
a neutral soap solution.
To Next Page
Loading...