8
hobie.com
1. Run the line through the cleat and under the
lower pulley.
2. Follow above the large pulley on the upper block.
3. Continue underneath the fiddle on the lower
block.
4. Bring the line back up to the upper block and run
over the lower pulley.
5. Tie the line off at the becket on the lower pulley
with a bowline knot.
6. Place a figure eight knot at the end of the line to
prevent the line from pulling out of the pulley.
Reeving Your Mainsheet Block
Assembly Required
Knots to Use
Figure 8 Knot Bowline Knot Halyard Knot Cleating off a Line
Lay the hulls on the
ground, about six feet
apart with the decals
facing down. Lay the
front and rear crossbars
between the hulls.
Hull Assembly
There is one drain plug in the rear of each hull used to drain the hulls.
The plugs should be in place before sailing. Remove the drain plugs
after sailing to empty water that may have leaked into the hulls. It is
best to travel with and store the boats with the drain plugs removed to
allow for pressure change due to heating, cooling and altitude change.
This will prevent warping of the hull surface.
To Next Page
Loading...
Need help?
General
