Operating the Device 53
Wake up time
Please note: Ex factory, the alarm clock function is not enabled. But it can be unlo-
cked by the physician or dealer with TRENDset PC software.
To activate the wake up alarm, press . For checking purposes, the programmed
wake up time is displayed for a short time. To deactivate the alarm, press . The acti-
vated alarm is indicated by a bell symbol on the display.
When the wake up alarm sounds, there are two options:
1.
Press the ON/OFF key once to stop the alarm for the next 5 minutes (Slumber mode)
and twice to deactivate it completely.
2. Press to end the alarm.
Setting the wake up time
1. Press the enter key for 1 second.
2. Use the selection keys and to select Wake Time.
3. Press the enter key and then use the selection keys and to set the hour.
Confirm your setting by pressing the enter key .
4.
Use the selection keys and to set the minutes. Confirm your setting by
pressing the enter key .
To Next Page
Loading...
