Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Keys, Doors, and Windows 21
To enter the vehicle, unlock the
doors.
.
If the engine is running, insert
the key and turn the ignition
switch to ON.
.
If the engine is not running, start
the engine normally.
Extending Engine Run Time
For a 10 minute extension, repeat
Steps 1–3 while the engine is still
running. The remote start can be
extended once.
When the remote start is extended,
the second 10 minutes will start
immediately.
For example, if the engine has been
running for five minutes, and
10 minutes are added, the engine
will run for a total of 15 minutes.
A maximum of two remote starts,
or a single start with an extension,
is allowed between ignition cycles.
The vehicle's ignition must be
turned on and then back off before
the remote start procedure can be
used again.
Cancelling a Remote Start
To cancel a remote start, do one of
the following:
.
Aim the RKE transmitter at the
vehicle and press and hold
/
until the park lamps turn off.
.
Turn on the hazard warning
flashers.
.
Turn the vehicle on and then off.
Conditions in Which Remote
Start Will Not Work
The remote vehicle start feature will
not operate if:
.
The key is in the ignition.
.
The bonnet is not closed.
.
The hazard warning flashers
are on.
.
The malfunction indicator lamp
is on.
.
The engine coolant temperature
is too high.
.
The oil pressure is low.
.
Two remote vehicle starts, or a
single remote start with an
extension, have already
been used.
.
The vehicle is not in P (Park).
Remote Control
Battery Replacement
As soon as the range of the Remote
Keyless Entry (RKE) transmitter
reduces, replace the battery.
Replace Battery in Remote Key
may also be displayed in the
instrument cluster when the battery
requires replacing.
To Next Page
Loading...
