HOLDEN MY19 RG Colorado - Headlamp High;Low-Beam; Changer; Headlamp Flash; Daytime Running

Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
90 Lighting
If the windscreen wipers operate
eight continuous cycles when it is
dark outside, the exterior lamps
illuminate automatically.
Headlamp High/
Low-Beam Changer
To switch from low to high beam,
push the lever.
To switch to low beam, pull the
lever.
{
Warning
Always switch the high beam
headlamps to low beam when you
approach oncoming or other
vehicles ahead. High beam
headlamps can temporarily
dazzle other drivers, which could
result in a collision.
Headlamp Flash
To flash the high beam lights, pull
the lever rearwards and release.
The lights stay on for as long as the
lever is held.
Daytime Running
Lamps (DRL)
DRL increase the visibility of the
vehicle during daylight. The LEDs in
the DRL can operate in two different
intensities:
.
Normal intensity for position
(park) lamps.
.
High intensity for DRL function.
The DRL operate in high intensity in
the following conditions:
.
The ignition is in the ON/RUN
position.
.
The exterior lamp control is in
the AUTO position.
.
The engine is running and the
shift lever is not in P.
Headlamp Levelling
Control
To set the headlamp level according
to vehicle load, turn the dial to the
required position.