Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Vehicle Care 241
For LED version only lamps
2 and 3 can be replaced; the
brake lamp should be replaced
by a Holden dealer.
4. Rotate the relevant bulb holder
anticlockwise.
5. Remove the bulb holder. Push
the bulb into the socket slightly,
rotate anticlockwise and
remove the bulb.
6. Insert a new bulb into the bulb
holder and refit the holder into
the tail lamp assembly and
fasten into place. Install tail
lamp assembly in body and
tighten the fasteners. Close the
covers and engage.
7. Switch on the ignition, operate
and check all lamps.
Number Plate Lamp
1. The number plate lamp is
located on the rear bumper.
To Next Page
Loading...
Need help?
General
