Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Instruments and Controls 75
Four-Wheel-Drive Light
C
The four-wheel-drive light comes
on when the transfer case is shifted
into four-wheel drive and the front
axle engages.
Some delay between the shifting
and the light coming on is normal.
See Four-Wheel Drive.
Descent Control System
5 illuminates or flashes green.
Flashes to indicate that the Descent
Control System (DCS) is activated,
reducing the vehicle's speed. This
will occur at speeds between
approximately 7 km/h and 30 km/h
(manual transmission) or
approximately 4 km/h and 30 km/h
(automatic transmission).
Illuminates after pressing the
5
button to indicate that the system is
enabled if vehicle speed is below
50 km/h.
See Descent Control System (DCS)
0 204.
Lane Departure Warning
(LDW) Light
If equipped, @ located in the centre
of the instrument cluster illuminates
briefly while starting the engine. If it
does not illuminate, have the vehicle
serviced.
@ illuminates green when LDW is
on and ready to operate.
@ changes to amber and flashes to
indicate that a lane marking has
been crossed without using a turn
signal in that direction.
See Lane Departure Warning (LDW)
0 214.
Vehicle Ahead Indicator
If equipped, V illuminates green
when a vehicle is detected ahead.
The indicator will display amber
when you are following a detected
vehicle ahead too closely.
See Forward Collision Alert (FCA)
System 0 207.
Electronic Stability
Control (ESC) Indicator
Light
.
The
G warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
The light flashes while driving, to
show that the ESC is actively
helping the vehicle with road grip
and stability.
.
If the light illuminates or does
not extinguish while driving,
contact a Holden Dealer
immediately.
.
See Driver Information Centre
(DIC) 0 78 and Electronic
Stability Control (ESC) 0 203.
To Next Page
Loading...
