Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Vehicle Care 257
8. Assemble the wheel wrench,
jack handle extensions and the
jack handle using a
screwdriver.
The vehicle may have a spare
wheel retainer cover.
9. Remove the spare wheel
retainer cover and insert the
chiselled end of the jack
handle, at a slight angle,
through the central hole in the
rear bumper and into the
funnel-shaped guide.
10. Rotate the wheel wrench
anticlockwise to lower the
spare tyre to the ground.
11. Continue to rotate the wheel
wrench until the spare tyre can
be pulled out from under the
vehicle.
12. Tilt the retainer and slide it up
the cable so it can be pulled up
through the wheel opening.
13. Place the spare tyre near the
flat tyre.
Wheel nut removal
14. Remove the centre cap by
placing the chisel end of the
wheel wrench into one of the
slots on the cap and gently
prise the cap out.
To Next Page
Loading...
