To Next PageTo Next Page
Need help?Do you have a question about the Holley Terminator Stealth EFI and is the answer not in the manual?
General| Fuel Type | Gasoline |
|---|---|
| ECU Included | Yes |
| Maximum Horsepower Rating | 650 HP |
| Self-Learning | Yes |
| Data Logging | Yes |
| ECU Location | Mounted on Throttle Body |
| Display Type | LCD |
| Touchscreen Included | No |
| Warranty | Limited |
Details the necessary fuel system components, including pump capacity, pre-filters, post-filters, and regulator type.
Instructions for welding a bung into the exhaust for oxygen sensor installation, including drilling and welding procedures.
Details on connecting throttle linkage and cables, ensuring smooth operation and proper geometry for transmissions.
Guidelines for routing the wiring harness through the firewall and within the engine compartment for optimal installation.
Instructions for connecting various sensors and loose wires, including power, ground, and signal connections.
Wiring instructions for using a stock inductive ignition coil for engine speed input, suitable for mechanical distributors.
Wiring for aftermarket Capacitive Discharge ignition systems, connecting to the "Tach Out" or wire these systems provide.
Adjusts core fuel parameters like Target AFR, Acceleration Enrichment, and Fuel Prime for basic engine tuning.
Allows adjustment of the target hot engine idle speed to achieve desired idle RPM and quality.
Adjusts ignition timing parameters at idle, cruise, and wide-open throttle for optimal engine operation.
