29.1.5A Touch Calibrate
The touch screen may be recalibrated by following the on screen prompts.
Figure 57
29.1.5B Local Info
Displays device and firmware information for the 3.5 Handheld.
Figure 58
29.1.5C Local Options
By selecting ‘Restore screens on startup’ the 3.5 Handheld will revert to the last screen used prior to powering off.
30.0 BASIC TUNING
The TERMINATOR™ systems allow the user to perform some basic tuning changes to help optimize mileage, drivability, and
performance. The tuning is split up into “Basic Tuning” and “Advanced Tuning”. The Basic Tuning allows changes to the Air/Fuel Ratio’s
the engine runs at and changes to Ignition Timing if a GM HEI or Ford TFI is used. The Advanced Tuning is typically not needed, but
allows changes to some items that are less commonly used, or require some careful understanding before changing.
From the HOME SCREEN, select TUNING, and BASIC. There are six areas you can modify, BASIC FUEL, FUEL LEARN, BASIC IDLE,
SPARK, DRIVE BY WIRE, and TRANSMISSION (with Drive by Wire and Transmission applying if applicable). These are reviewed below.
Figure 59
To Next Page