•
GPS Mode Switch
When turning on the transmitter, the default mode is the GPS Mode. Turn
off GPS by sliding GPS switch. Check the icon " l " or "
a
"on the LCD
screen to confirms GPS status.
•
Return to Home (RTH)
Press the button to start the RTH, the transmitter makes a beep sound
and the drone will fly back to the recorded Home Point.
Press the RTH button again to exit RTH procedure and regain control of
the drone.
•
Emergency Stop
Press and hold the button " o " for 3 seconds, the motor will stop immedi-
ately.
Attention:
The Emergency Stop function should only be use during
emergency to avoid any damage or injury.
•
Photo/ Video
Short press the button and the camera icon "
" on the LCD screen
flashes once, the camera takes one photo.
Long press the same button, the video icon " SI " on the LCD screen
flashes slowly the camera is taking video. Long press again will exit
shooting.
•
Speed Switch
Long press the button " % " in the upper right corner, the LCD screen
showing " 1121", and you will hear a beep, which means the drone is at the
low speed.
Long press the button " %" again, the LCD screen showing "
and you
will hear two beeps, which means the drone is at the high speed.
-09-
To Next Page
Loading...
