OPERATI ON
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Seit e 3 4
METALLDREHMASCHINE / METAL TURNING LATHE ED 750FD
1 4 OPERATI ON
1 4 .1 Notes on Operation
b) Check the screw
Check all bolted connections and tighten them if necessary.
c) Checking t he oil level
Check it the oil level and fill it if necessary after some oil
1 4 .2 operation
W ARNI NG
Setting each tim e you start speed control to the low est level !
NOTE: Failure to comply results in damage to the engine and loss of
w arranty !
1 4 .2 .1 Engine starting / stopping
If you want to press the ON OFF switch, the com-
bined EMERGENCY STOP switch must be in the
open state. They pull to open the emergency OFF
switch to the left
To start, press the green button˝I ˝
To top, press the red button˝O˝
I NFO: In
the closed state of the main switch can be operated as an EMERGEN CY STOP switch
1 4 .2 .2 Setting the direction of spindle rotation
Turn on the direction of rotation switch (1 ) to the position ˝ F ˝ for spindle
mode counterclockwise, and in the position ˝ R ˝ for spindle mode clockwise.
In the position ˝ O ˝ is switched to idle
CAUTI ON
W ait at each change of direction necessarily, the m achine stops, otherw ise
the m achine m ay be dam aged!
To Next Page
Loading...
