HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Strana 37
STOLNÍ A ZRACOVACÍ PILA / COMPOUND TABLE/MITRE SAW TK 305
6. Install the extend pole
Hold the “extend pole” with your hand. Then insert it
to the hole of the base side until it to go on ; when
the pole and hole are in a straight line.
As same as the other side.
7. Use the clamp groupware to work.
c) Put the board on the “circular pan” ;
d) Reference “location ruler” to select a cutting
length, then screw up the “clamp groupware”
knob until it to clamp the board.
8. Use the mitre saw
f. Hold the handle and trigger switch;
g. Press the “mitre drop & lock button” down;
h. Push down the mitre head to cut the board.
i. If the cutting board too short. So you must
use the “safety push stick”.
j. Cutting the board until it to server.
k. Loosen the trigger of the mitre, until it rise
slowly.
l. Release your hand
14.2.4 Adjusting the sawing angle
The default angle between the saw blade and the circular
pan is 90°. Use a 5mm hex key to check the angle between
the saw blade and the circular pan.
5. Loose the “Mitre swing and control angle knob”
6. Loose the “verticalis lock screw, Then swing the
mitre handle when the indicator stay a 0°.
To Next Page
Loading...
