●
Do not install where it becomes high temperature. It causes to
igniting, injuring or electric shock due to inside heating.
●Please use specified power supply cable, batteries or fuse.
It causes to heating or firing.
●
Do not leave the power plug as it is while it is pulled out of the unit.
If the plug gets wet, it causes to heating or firing due to short circuited.
●
Be sure to wire in order to prevent the cables from interfering to
operate
oat. If feet of crews or operating equipments are caught i
cables, it causes to the accident.
※
Do not put the heavy objects on cables or do not bend cables
excessively.
●Do not disassemble or modify cables.
It causes to firing, electric shock or injuring.
●
Do not use the damaged cables.
It causes to firing or electric shock.
●Do not pull the cable when you pull out the plug.
It causes to firing or electric shock because the cable is broken.
※When you pull out the plug, be sure to have it in your hand an
pull it.
1-2. Handling of cables
●Work on the board is too unstable and risky.
Installation and maintenance of transducer or water temperature
sensor should be done after you land and fix the boat.
1-3. Handling of transducer and water temperature sensor
2
To Next Page
Loading...