26
CONTROLS AND FEATURES
Common Controls
Power Trim/Tilt Switch
(side-mount type)
POWER
TRIM/TILT
SWITCH
CONTROL
LEVER
(panel-mount type)
POWER TRIM/TILT SWITCH
CONTROL LEVER
DUAL TYPE
(top-mount type)
SINGLE TYPE
POWER TRIM/TILT SWITCH
CONTROL
LEVER
(LEFT)
POWER TRIM/TILT SWITCH
(RIGHT)
CONTROL
LEVERS
The power trim/tilt switch is located
on the control lever. It is a rocker
switch with UP and DN (down)
positions for changing the angle of
the outboard motor.
You can use the power trim/tilt switch
anytime whether the boat is
underway, stopped, or the ignition
switch is in the OFF position. It is
necessary for the ignition switch to be
in the ON position for the trim meter
to indicate the outboard motor angle.
Trim the outboard motor to obtain the
best performance and stability (p. 52).
Tilt the outboard motor for shallow
water operation, beaching, launching,
or mooring.
For dual mount outboard motors, tilt
them up at the same time.
31ZX26040.book Page 26 Friday, July 25, 2014 5:14 PM
To Next Page
Loading...
